Forum for users of Vectric products

Dec 13, 2020 · How can you move the parts of the box around on the material to optimize my material. When I try to move a part I do not get the cut vector to move the part. Al

Aug 10, 2020 · I've watched the overview videos on the vectric site, but they're not as specific as I'm looking for. Also, none of the settings have bit depth. Does that even matter, really? (I'm …

Jan 18, 2014 · The guys at vectric worked for Delcam. Delcam cost around $7500 + support. Aspire is much easier to use and support is free. Don 01-18-2014, 01:19 PM #3 phil_o Senior …

Sep 21, 2014 · I've had some good success with lithopanes in .25 inch Corian with a lot of help from this forum. My final cutting depth has been .12 inches leaving about half

Apr 27, 2014 · Hello,I am cutting a clock gear that has 2 different size holes in it how do I change to the other size cutter,or do I need to do a new setup.thanks

Apr 12, 2007 · In VCarve Pro v3.1, is there a way to change the safe z height after the material is defined? I have one particular tool path that might be trouble and I wanted to add a little height …

Apr 17, 2013 · In the Vectric software that is a good idea. I don't know of any other technique for checkingthis. Typically, if you are creating the artwork to be used with the drag knife, you …

Dec 20, 2009 · First what is the best or minimum resoultion of a picture used to make a Lithophane? minimum pixels or DPI. Secondly, if I try a multiple pass for photo vcarve