SHALLOW WELL JET PUMPS STEP 1 Make sure the well is pumped clean and that sand and grit are absent. STEP 2 Before installing a shallow well or centrifu-gal pump make sure the total suction lift does not exceed 25 feet.

The motor can be replaced with any standard Nema 56J jet pump motor (of proper HP for each pump) by referring to the following instructions. Follow steps as outlined under Rotary Seal Replacement and Pump Disassembly.

Install a priming tee, priming plug, and suction pipe to the pump (Figure 2). Connect the pipe from the well to the pump suction port, using the fewest possible fittings, especially elbows, as fittings increase friction in the pipe.

Dec 5, 2018 · INSTALLATION OF JET PUMP (VERTICAL) INSTALLATION The Jet monobloc should be installed in a clean, dry location with proper ventilation. Do not install in open air without sufficient covering. The Monobloc can be installed either over a well or away from it.

The installation diagram of a deep well jet pump typically includes several key elements: the well itself, the jet assembly, the pressure switch, the pressure tank, and the plumbing connections.

There are four main types of jet pumps; deep well, shallow well, multistage and mini. They do not require coupling as they are known for being relatively easy to install.

Learn about the installation process of a jet pump with the help of an informative diagram. This article provides step-by-step instructions and highlights the various components involved. Find out how to set up a jet pump system efficiently for optimal performance.

Carefully read and follow all safety instructions in this manual and on pump. Keep safety labels in good condition. Replace missing or damaged safety labels. Make workshops childproof; use padlocks and master switches; remove keys.

NOTE: When the 8200 and 8600 Series pumps are used without bolt-on SW ejector, for higher capacity, the 1" NPT tapping below the 1 1/4" NPT suction tapping must be plugged.

Install the product to enable easy inspection, maintenance and service. We recommend that you place the product as close to the liquid to be pumped as possible.