About 393,000 results
Open links in new tab
  1. To that end, we first develop a multibeam satellite model that accounts for prop-agation effects, interference among beams, and atmospheric attenuation. Next, we formulate the joint power …

  2. A Bandwidth Statistical Multiplexing and Control Method for Satellite ...

    The joint bandwidth and power allocation iterative algorithm based on duality theory was proposed to obtain the optimal solution of satellite power and bandwidth resources in a multi-spot-beam …

  3. follows: ”How should the satellite constellation orbit, altitude, and elevation angle selections be sized for a given market demand distribution, satellite transmit power, antenna size, channel …

  4. Self interference cancellation for bandwidth optimization on satellite

    Nov 1, 2017 · Block digram of VSAT Satellite Link. Proposed Self Interference Cancellation for Satellite Communication systems. Performance of the the proposed receiver of Figure 2 …

  5. In this paper, we exploited the synergy of linear precoding and flexible bandwidth allocation for geostationary (GEO) high throughput satellite systems. We formulate an optimization problem …

  6. Nov 15, 2003 · Figure 1: Transmitter Module High-level Block Diagram. The modem loss budget allocates a total of 1 dB of degradation at an E b/N 0 of 14 dB to these two effect since the …

  7. A Frame Bandwidth Optimization Algorithm for Satellite

    Dec 19, 2021 · In order to solve the constraints of traditional frame generation algorithm on the multi-data transmission rate of satellite navigation system effectively, optimize the system …

  8. Therefore, this thesis aims to develop a new method- ology of power and bandwidth allocation in multibeam satellite systems taking into account interferences and to investigate the …

  9. DVB-S2 modem algorithms design and performance over typical satellite

    The high-level system block diagram considered is shown in Figure 1. The first block in the chain is the gateway modulator which is described in detail in Section 2.1. The RF output signal is …

  10. • A good short bandwidth efficient modulation code (trellis or block) is used as the inner code and rela-tively powerful Reed-Solomon (RS) code is used as the outer code. • With properly …

  11. Some results have been removed
Refresh