Feb 6, 2013 · Snug up the clamp until it will just slid around the flange. Set the clamp to the position marked earlier and tighten the clamp to 160 in-lb. Loosen the nut and torque to 50 in …

Jul 12, 2010 · The v-band clamp is tightened to 50 lb/in (that's inch, not feet) according to International.

Feb 27, 2021 · From the manual and other sources, is the below the correct torque for the V-clamp that holds the Y-Pipe to the turbo and the turbo to the down-pipe...

Jun 1, 2010 · So I have up-pipe collector attached to the turbo, do I torque the V-band clamp down to 50lb-in as per Pockets (international) numbers or 110-130 lb-in as per garrett …

Initially tighten V Band Nut to 18Nm (to seat V Band) then loosen to 6Nm, Retighten to 13-l5Nm final torque value.

Initially tighten V Band Nut to 18Nm (to seat V Band) then loosen to 6Nm, Retighten to 13-l5Nm final torque value. Check Oil Drain ls in correct position to attach Oil Drain and Oil supply pipes.

Jun 13, 2013 · I read some notes that the turbo housing clamp alone should be tightened to 13ft/lbs, loosened to 4ft/lbs, and then tightened to 12ft/lbs. Really? I don't have a torque …

Sep 27, 2007 · I am trying to find the torque spec. on the turbo band clamp that the downpipe and turbo share. I did a search in the forum and tech folder and haven't found the foot pounds for …

mounting bolts and torque down to 18 ft-lbs. (fig. 6) Align the up-pipe collector with the turbo flange ensuring that the pin on the c. llector engages with the hole in the turbine housing. This …

May 16, 2009 · The "/" means divided by, torque is a force times (*) a distance. Your torque wrench is not accurate enough to be worried about 9 or 9.1 ft*lbs, although I understand your …